Glue Dispenser Machine Pneumatic Dispensing Machine Semi-Automatic//Manual Glue Dispenser Glue Dispenser Solder Liquid Controller

SpecificationColor: BlackModel: 982Material: MetalSpitting Mode: Manual / Semi-automaticMinimum Drip Volume: 0.01mlSpitting Time Interval: 0.1-9.9sAutomatic Timing(Can Be Set): 0.01-30s Repeat Accuracy: ±0.5%Internal Voltage: 12-24DCInput Air Pressure: 2.5-7bar(35-100psi)Output Air Pressure: 0.1-5.5bar(1-78psi)Power Supply: 110V AC, 60Hz Power Consumption: 20WPlug Specification: American Standard 110VProduct Size:23*15*6cm/9.05*5.9*2.36inPackage Size:20*26*14cm/10*9*12.5inGross Weight: 2.1kg/4.63 lbsPackage Included1* Dispenser Main Unit1* Manually Switch1* Foot Switch1* Air Tube1* Connection Tube1* Power Cord1*Dispenser Stand2* 30CC Liquid Barrels6* Dispensing Needles1* Chinese and English ManualNotes: 1. The input high pressure should not exceed 7 bar (100psi), and the maximum working pressure of the glue dropper should not exceed 5.5 bar (78psi). If the working air pressure is above 4 bar, please switch to aluminum connectors.2. If available, store all materials at a constant temperature (5°) as directed to ensure that the concentration does not change significantly during use.3. When the material concentration is too large (flow difficulties), can not drip, if you want to use it, according to the manufacturer's instructions dilute the use; before work, the material must be fully stirred evenly to ensure that the size of the drip consistent.4. Automatic state, the general air pressure adjustment in the machine at 1-2.7bar (15-40psi) is more appropriate. When working in the automatic state, the strength of the vacuum tube pumping back air should be adjusted to the proper position. Too much pumping back will flush the piston and destroy the normal operation. 5. Automatic state work, according to the actual situation, timely removal of the material left at the needle nozzle, these materials gradually curing will block the muzzle discharge and back pumping; after work, the barrel should be cleaned in time, otherwise, the barrel's disassembly will be very difficult.6. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement and make sure you do not mind before ordering.

• Solid and Durable: The glue dispenser machine is made of metal, strong and stable, not easy to damage and corrosion, but also uses the fourth generation chip design circuit board, significantly improving stability.
• Vacuum Back Suction: This semi-automatic glue dispenser machine is equipped with a vacuum back suction device, which can effectively guard against the glue from dripping during use to achieve a more accurate glue dripping, and ensure a clean and tidy working environment.
• Precise Drip: The minimum drip volume is 0.01ML, and the spitting interval is 0.1-9.9s. It can drip precisely and achieve a repeat accuracy of about 0.5%. It is also equipped with a single-hole hand control switch, allowing you to control it personally by hand for more accuracy and timeliness.
• Semi-automatic Design: It can be both automatically dripped by the machine and precisely controlled by a single-hole hand switch. If you want to free your hands, you can set the switch to the automatic position, to achieve a more efficient and higher-quality working method.
• Wide Application: This pneumatic dispensing machine is suitable for most of the yellow glue, quick-drying glue, epoxy resin, etc. in the market, and is widely used in bonding various electronic components, machine production, instrumentation, jewelry, and other objects.